Battery cable, ground
Battery cable, ground |
To remove |
1. |
Remove the
battery
.
|
2. |
Remove the battery's air inlet pipe.
|
3. |
Cars with petrol engine:
Press in the catch and move aside the fuse box in front of the battery.
|
4. |
Cars with diesel engine:
Press in the catch and move aside the power steering fluid reservoir.
|
5. |
Loosen the catches and move aside the heat shield, letting any components remain on the heat shield.
|
6. |
Cars with theft protection:
Detach the bonnet switch from the battery cover.
|
7. |
Undo any wiring harness clips from the battery cover.
|
8. |
Remove the bottom of the battery cover.
|
9. |
Remove the cable's nut and bolt.
|
To fit |
1. |
Position the cable. Fit the cable's nut and bolt.
|
2. |
Fit the bottom of the battery cover, making sure the positive cable lies in the cable duct.
|
3. |
Fit the bottom of the battery cover; use
74 96 268 Thread locking adhesive
.
Tightening torque 24 Nm (18 lbf ft) |
4. |
Cars with theft protection:
Fit the bonnet switch to the battery cover.
|
5. |
Secure wiring harness to the battery cover where necessary with a clip.
|
6. |
Fit the heat shield.
|
7. |
Cars with diesel engine
:
Fit the power steering fluid reservoir.
|
8. |
Cars with petrol engine:
Fit the fuse box.
|
9. |
Fit the battery's air inlet pipe.
|
10. |
Fit the
battery
.
|
11. |
Reset the car; see
Procedures after battery disconnection
.
|