SAAB WIS ONLINE

Accelerator pedal position sensor (379), PSG16

Accelerator pedal position sensor (379), PSG16

Location

Accelerator pedal position sensor (379)

Main task

The task of the position sensor is to translate the driver's request from an accelerator position to instructions the engine control module can understand and process. This is directly affected by the accelerator.

Type

The position sensor houses two potentiometers that vary voltage on the control module sensor inputs based on the position sensor's shaft angle.

The position sensor consists of a resistance track with collector shoes. The collector shoes are mounted on the position sensor shaft and move over the resistance track in relation to the movements of the shaft.

To ensure that information from the position sensor is accurate, there are two different potentiometers. Both are supplied 5 V, but the signal to the control module is always twice as much on P1 as on P2, 0-5 V on the one and 0-2.5 V on the other. This ensures both the function and diagnosis of the position sensor. See the illustration of the inner connections of the sensor.

When the position sensor angle is less than approx. 9°, the potentiometers are in idle position and voltage on the control module inputs is less than 1.1 V and 0.55 V respectively.


Connection

Pin No.
Signal type
Description
1 Power supply, 5 V Connected to ECM pin 31(K).
2 Power supply, 5 V Connected to ECM pin 7(K).
3 Signal, P1 Connected to ECM pin 33(K).
4 Ground Connected to ECM pin 9(K).
5 Ground Connected to ECM pin 21(K).
6 Signal, P2 Connected to ECM pin 45(K).