SAAB WIS ONLINE

Wiring harness, roof, 4D

Wiring harness, roof, 4D

To remove


1. Undo the cable for the battery's negative terminal.

2. Remove the Headlining .

3. Remove the clips (B) for the left-hand side trim and fold down the inspection cover (A).


4. Remove the left-hand rear speaker .

5. Open the clips (A) for the wiring harness for the left-hand C-pillar.


6. Unplug the connectors (B) from the REC and route the wiring harness up through the parcel shelf.

7. Unplug the connector (A) for the high-level rear light.


8. Unplug the connector (A) at the front edge of the headlining.


9. Undo the clips (A) and unplug the connector (B) at the right-hand A-pillar.


10. Unplug the connectors for the microphone, interior lightning, anti-theft alarm, interior temperature sensor and the sunroof.


11. Unplug the connector (A) for the rear roof lighting.


12. Remove the wiring harness from the headlining and remove the tape carefully.


Important

Take care so as not to crack the headlining.



To fit

Important

Fasten the wiring harness correctly so that there is no risk of it chafing or rattling.


Note

Spray all the connectors with "Kontakt 61" or similar to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.



1. Position the wiring harness and affix with new tape.


Important

Take care so as not to crack the headlining.


2. Plug in the connector (A) for the rear roof lighting.


3. Plug in the connectors for the microphone, interior lightning, anti-theft alarm, interior temperature sensor and the sunroof.


4. Plug in the connector (B) at the right-hand A-pillar and fasten the clips (A).


5. Plug in the connector (A) at the front edge of the headlining.


6. Plug in the connector (A) for the high-level rear light.


7. Route the wiring harness through the parcel shelf and plug in the connectors (B).


8. Close the clips (A) for the wiring harness on the left-hand C-pillar.

9. Fit the left-hand rear speaker .

10. Fit the clips (B) for the left-hand side trim and close the inspection cover (A).


11. Fit the Headlining .

12. Connect the negative cable of the battery.

13. Set the clock and program any radio code.

14. Cars with pinch protection: Carry out Programming the pinch protection .