Brake pads, front, level 1 and 2
|
|
Brake pads, front, level 1 and 2
|
|
3.
|
Remove the retaining spring from the brake caliper.
|
|
4.
|
Press in the piston by prising with a screwdriver against the brake pad.
|
|
5.
|
Remove the protective covers and guide pins.
Lift off the hydraulic body.
|
Note
|
|
Be careful when handling the brake hose.
|
|
|
6.
|
Remove the inner brake pad from the caliper and the outer brake pad from the bracket.
Clean the inside of the brake caliper and check the dust covers.
|
|
2.
|
Place the outer brake pad into the carrier.
Fit the inner brake pad into the hydraulic body.
|
Note
|
|
The inner brake pad must be fitted so that the arrow points in the direction of rotation of the brake disc for forward travel.
|
|
|
3.
|
Place the hydraulic body into the carrier.
Fit the guide pins.
Tightening torque 28 Nm (21 lbf ft)
|
|
4.
|
Fit the protective covers.
|
|
5.
|
Fit the retaining spring to the brake caliper. Lay the outer contact surfaces against the bracket and push the centre of the clip.
|
|
8.
|
Depress the brake pedal repeatedly in order to press out the brake pistons.
|
|
9.
|
Check the brake fluid level and top up as necessary.
|
|
10.
|
Check the operation of the foot brake.
|
