SAAB WIS ONLINE

Steering gear, LHD

Steering gear, LHD

To remove

Important

Scrupulous cleanliness must always be observed during all work with hydraulic components.



1. Diesel engine: Remove the upper engine cover.

2. Clamp the return hose using 30 07 739 Hose pinch-off pliers .

3. Position the steering wheel and the wheels so that they face straight ahead. Use woven tape to secure the steering wheel to the dashboard.

4. Raise the car.

5. Remove the front wheels.

Diesel engine: Remove the lower engine cover.

6. Remove the nuts securing the track rod ends to the steering swivel members.

Remove the track rod using 87 91 287 Puller, 150 mm .


7. Remove the anti-roll bar links from the anti-roll bar. Hold with a thin 17 mm open wrench so that the ball joint does not turn.

8. Remove the steering shaft joint from the steering gear.


9. Place a receptacle under the car. Detach the delivery line and the return line from the steering gear. Plug the lines.

10. Remove the heat shield from the steering gear.


11. Remove the steering gear bolts, nuts and washers.

12. Twist up the anti-roll bar as high as possible and lift out the steering gear through the wheel housing on the passenger side.


To fit


1. Lift the steering gear into place through the wheel housing on the passenger side.

2. Fit the steering gear to the subframe.

Tightening torque 50 Nm +60° (37 lbf ft +60°)


3. Fit the heat shield to the steering gear.

4. Fit the delivery line and return line to the steering gear. Fit new O-rings.

Tightening torque 28 Nm (21 lbf ft)


5. Twist the anti-roll bar down into position. Fit the anti-roll bar links to the anti-roll bar. Hold with a thin 17 mm open wrench so that the ball joint does not turn.

Tightening torque 64 Nm (47 lbf ft)


6. Fit the track rod ends to the steering swivel members.

Tightening torque 35 Nm (26 lbf ft)

7. Fit the steering shaft joint to the steering gear. Clean the threads and apply 74 96 268 Threadlock to the threads.

Tightening torque 30 Nm (22 lbf ft)


8. Diesel engine: Fit the lower engine cover.

9. Lower the car to the floor.

10. Refit the wheels .

Tightening torque 110 Nm (81 lbf ft)

11. Remove the hose pinch-off pliers and fill with power steering fluid .

12. Diesel engine: Fit the upper engine cover.

13. Remove the tape used to prevent the steering wheel from moving.

14. Bleed the power steering system and check for leaks.

15. Carry out a wheel alignment .