SAAB WIS ONLINE

Wheel hub, rear

Wheel hub, rear

To remove


1. Raise the car.

2. Remove the wheel.

3. Remove the retaining spring from the brake caliper.


4. Remove the protective covers. Lift off the hydraulic body and suspend it with a hook in the brake pipe holder.

Note

Make sure the brake pipe is not damaged.


Remove the outer brake pad.

5. Remove the brake caliper holder.


6. Remove the brake disc.

7. Remove the wheel sensor connector.


8. Remove the hub and the brake shield.


To fit


1. Clean the contact surfaces. Fit the hub and the brake shield with new nuts.

Tightening torque 50 Nm +30° (40 lbf ft +30°)


2. Fit the wheel sensor connector.

3. Clean the contact surfaces between the hub and the brake disc.

Fit the brake disc and the lock bolt.

Tightening torque 7 Nm (5 lbf ft)


4. Clean the contact surfaces between the brake caliper holder and the steering swivel member.

Fit the brake caliper holder with 74 96 268 Nut lock .

Tightening torque 130 Nm +45° (96 lbf ft +45°)

5. Remove the inner brake pad and screw in the brake piston using 89 96 969 Resetting tool and 89 96 977 Adapter .


6. Fit the brake pads.

Note

Make sure that the springs on the inner pad rest in the piston groove.


7. Fit the brake housing.

Tightening torque 28 Nm (21 lbf ft)

Fit the protective covers.

Fit the retaining spring to the brake caliper.


8. Fit the wheel .

9. Lower the car to the floor.

10. Depress the brake pedal several times to press out the self adjustment of the brake pistons and the parking brake.