Front wing
Front wing |
To remove |
1. |
Raise the car. Remove the spoiler shield. Unplug and remove the connector. Detach the washer hose if required.
|
2. |
Remove the wheel.
|
3. |
Remove the wing liner and insulation.
|
4. |
Remove the clip from the rubber moulding on the sill cover by pressing in the clip from the front with a pair of pliers.
|
5. |
Open the bonnet.
|
6. |
Remove the plastic rivets from the upper radiator crossmember.
|
7. |
Remove the upper bolts securing the headlight.
|
8. |
Detach the corner of the bumper shell from the retainer and position the shell under the guide.
|
9. |
Remove the lower bolts securing the headlight. Lift up the catch to release the headlight from the spacer.
|
10. |
Lift out the headlight and unplug the connector.
|
11. |
Remove the nut and bolts from the upper section of the front wing.
|
12. |
Remove the clip on the scuttle panel.
|
13. |
Slacken the bolt by the front door hinge.
|
14. |
Remove the
Sill cover
|
15. |
Remove the lower bolt for the wing from the sill.
|
16. |
Lift up the front edge of the front wing's mounting lug.
|
17. |
Remove the side direction indicator.
|
18. |
Remove the front wing.
|
To fit |
1. |
Position the mounting lug against the slackened bolt by the front door.
|
2. |
Position the wing under the bulkhead cover and the tab on the upper radiator crossmember. Fit the mounting lug over the stud at the front edge.
|
3. |
Thread all the bolts.
|
4. |
If a new wing is fitted, adjust its position relative to the bonnet and door. If refitting the old wing, position it as before.
|
5. |
Fit the nut on the mounting lug at the front and tighten all bolts. Fit the clip on the scuttle panel.
|
6. |
Fit the
Sill cover
.
|
7. |
Plug in and fit the direction indicator.
|
8. |
Pull out the clip in the rubber moulding using a pair of pliers.
|
9. |
Fit the insulation behind the wheel.
|
10. |
Plug in the headlight.
|
11. |
Angle in the headlight and guide the locating pin into the hole.
|
12. |
Fit the lower and upper bolts that secure the headlight.
|
13. |
Lift up the bumper shell under the headlight. Press the bumper into the retainer so that the clasps engage.
|
14. |
Fit the plastic rivets to the upper radiator cross member.
|
15. |
Fit the wing liner and wheel.
|
16. |
Fit the bolts to the bumper shell in the wing liner. Fit the spoiler shield. Plug in and attach the connector. Fit the washer hose where appropriate.
|
17. |
Check the fit and alignment of the front wing and bumper and check the headlight alignment.
|