Suspension tower
Suspension tower |
To remove |
The illustrations show the right-hand side of a RHD car.
1. |
Drill out the spot welds on the suspension tower. (The lower illustration is taken from underneath.)
|
2. |
Tap out the suspension tower.
|
To fit |
1. |
Straighten and grind the surfaces of the replacement panel and body that are to be welded.
|
2. |
Apply welding primer to the surfaces that are to be plug or spot welded.
|
3. |
Fit the replacement panel in place and secure it with some welding clamps.
|
4. |
Secure the suspension tower with spot and plug welds.
|
5. |
Grind the welds.
|
6. |
Wash away surplus welding primer. Welding primer reduces the adhesion of paint, filler and sealant.
|
7. |
Apply primer to all bare metal surfaces.
|
8. |
Seal joints and seams with sealant.
|
9. |
Apply rust protector after painting. Use Terotex HV 400.
|