Floor carpet, front
Floor carpet, front |
To remove |
1. |
Remove
the front seats
.
|
2. |
Remove
the floor console
.
|
3. |
Remove the air duct to the rear air vent.
|
4. |
Remove the bellows from the air ducts to the rear floor vents.
|
5. |
Where appropriate remove the amplifier and unplug its connector.
|
6. |
Detach the seat connectors from the floor.
|
7. |
Detach the handbrake cables.
|
8. |
Remove the
gear lever housing
. Let the cables remain in place.
|
9. |
Remove the screws holding the floor console aluminium frame to the floor tunnel.
|
10. |
Remove the clips from the ignition switch cabling.
|
11. |
Lift out the centre console aluminium frame with the complete handbrake unit. Note the screw positions.
|
12. |
Remove the two lower console support legs.
|
13. |
Remove the gyro unit.
|
14. |
Disconnect the ACM connector and ground cable.
|
15. |
Remove the ACM.
|
16. |
Remove the metal support from the exhaust tunnel under the heating and ventilation unit.
|
17. |
Remove the forward scuff panels and the lower A-pillar side panels.
|
18. |
Remove the
sound insulation panel, driver
and
sound insulation panel, passenger
|
19. |
Detach the carpet from the B-pillar trim.
|
20. |
Free the carpet from the floor vents and detach the front carpet from the rear carpet.
|
21. |
Lift up the carpet around the floor console mountings and screws.
|
22. |
Lift out the front carpet.
|
To fit |
1. |
Lift in and position the carpet.
|
2. |
Slide the carpet under the pedals and the fan housing.
|
3. |
Fit the carpet over the guide pins and mountings. Manoeuvre the carpet over the air ducts and the seat connectors.
|
4. |
Fit the edges of the carpet under the B-pillar trim and align the front and rear carpets.
|
5. |
Fit the
sound insulation panel, driver
and
sound insulation panel, passenger
.
|
6. |
Fit the forward scuff panels and the lower A-pillar side panels.
|
7. |
Fit the metal support on the exhaust tunnel under the heating and ventilation unit.
|
8. |
Fit the ACM.
Tightening torque 10 Nm (7 lbf ft) |
9. |
Reconnect and fit the ACM connector and ground cable.
|
10. |
Fit the gyro unit.
|
11. |
Fit the two lower console support legs.
Tightening torque 33 Nm (24 lbf ft) |
12. |
Position the floor console and handbrake assembly and fit the screws holding the aluminium frame to the floor tunnel.
|
13. |
Fit the ignition switch cable clips.
|
14. |
Fit
the gear lever housing
.
|
15. |
Attach the handbrake cables.
|
16. |
Fasten the seat connectors.
|
17. |
Where appropriate fit the amplifier and plug in its connector.
|
18. |
Fit the bellows to the air ducts for the rear floor vents.
|
19. |
Fit the air duct for the rear air vent.
|
20. |
Fit
the floor console
.
|
21. |
Fit
the front seats
.
|