Belt reel with tensioner, front, CV
|
Belt reel with tensioner, front, CV
|
Warning
|
An airbag system that can include an integrated seat belt tensioner comes as standard on the Saab 9-3.
|
Work in accordance with the safety and handling instructions described in WebWIS group 8, Body - Airbag system - Technical description - Safety and handling instructions.
|
|
|
|
|
Warning
|
The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.
|
|
|
|
|
6.
|
Remove the upper and lower trim strips from the seat. Fold the upholstery and padding back.
|
7.
|
Remove the upper inner cover.
|
8.
|
Remove the strap guide.
|
9.
|
Remove the lower belt fixing.
|
10.
|
Belt with thin locking tab:
Pull the seatbelt out of the guide cover.
|
11.
|
Remove the fixing screw for the belt reel inner cover.
|
12.
|
Remove the belt reel connector.
|
13.
|
Remove the belt reel fixing screw.
|
14.
|
Press the belt reel inner cap forwards and lift the belt reel.
|
1.
|
Press the belt reel inner trim forwards and position the belt reel.
|
2.
|
Fit the inertia reel.
Tightening torque 47 Nm (35 lbf ft)
|
3.
|
Attach the belt reel connector.
|
4.
|
Fit the screw for the belt reel inner cover. Check that the lower trim clip is in place.
|
5.
|
Fit the upper strap guide and upper inner cover.
|
6.
|
Belt with thin locking tab:
Thread the seatbelt into the guide cover.
|
7.
|
Guide the belt into the lower control.
|
8.
|
Fit the belt end fitting to the seat.
Tightening torque 47 Nm (35 lbf ft)
|
9.
|
Fold back the padding and upholstery and fit the strips to the seat.
|
14.
|
Fold back the backrest and reset the seat.
|
15.
|
Check the operation of the seat belt.
|
17.
|
Check using the diagnostic tool as follows:
Connect the diagnostic tool to the data link connector under the dashboard.
Delete any fault codes.
Turn the ignition OFF and then ON again. Wait at least 1 minute with the ignition on.
Check whether a diagnostic trouble code is shown:
If a diagnostic trouble code is shown:
Carry out fault diagnosis according to the instructions under respective trouble codes.
If a diagnostic trouble code is not shown:
The assembly was successful. Disconnect the diagnostic tool.
|