SAAB WIS ONLINE

PSG16 / P0335 FA

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general) Performance loss. A/C not working, no cooling.

  P0335 FA


Engine Speed Sensor. No Signal During Engine Running.

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

Performance loss.

A/C not working, no cooling.

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Engine running.
Engine speed more than 850 rpm.
NONE of the following DTCs must be detected:
P0016
P0219
P0337
P0340, P0342, P0343

Fault criteria:

Time between two crankshaft signals more than 40 ms 16 times running.

System reaction to a fault:

Limp Home, fuel limitation.
Output to the A/C relay is switched off.
The control module uses pump rpm x2 as a substitute value.

Checking the wiring harness

Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force.
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards:


Functions in the diagnostic tool related to the fault:

Test value:
Engine RPM
(See also description of readings/activations in diagnostic tool)