SAAB WIS ONLINE

PSG16 / P0670 04

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general)

  P0670 04


Glow Control Unit. Open Circuit.

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Ignition ON.
Output NOT activated.

Fault criteria:

No voltage on the control module output for more than 0.6 s

System reaction to a fault:

None

OK report:

Fault criteria NOT fulfilled for 0.6 s.

Checking the wiring harness

Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force.
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Data link from glow plug control module should switch high/low inversely to activation lead from PSG 16 to glow plug control module.