Dynamic oil level check, removing and fitting
|
|
Dynamic oil level check, removing and fitting
|
|
1.
|
Undo the cable set connector for the dynamic oil level check (1).
|
|
2.
|
Undo the oil drain screw - put a receptacle underneath.
|
|
3.
|
Remove the dynamic oil level check (2) from the oil pan.
Clean the sealing surfaces and remove remains of sealant.
|
|
1.
|
Fit the oil level check together with a new sealing ring (1) onto the oil pan - tightening torque 8 Nm
|
Note
|
|
Recut the threads before reuse and apply locking compound (red) when fitting the bolts. Mounting time including checking torque must not exceed 10 min.
|
|
|
2.
|
Fit the oil drain plug with a new sealing ring onto the oil pan.
|
|
3.
|
On versions with hex bolt (metal sealing ring) - tightening torque 45 Nm.
|
|
4.
|
On versions with inside Torx screw (rubber sealing ring) - tightening torque 14 Nm.
|
|
5.
|
Put together the cable set connector for the dynamic oil level check - note the cable routing.
|
|
6.
|
Fill with engine oil to the "MAX" mark on the dipstick.
|
