Engine oil change
Engine oil change |
1. |
Open the bonnet.
|
2. |
Raise the car.
|
3. |
Drain the engine oil:
|
• |
Place a receptacle under the car.
|
• |
Remove the drain bolt.
|
4. |
Remove the oil filter cartridge.
|
• |
Place a receptacle underneath.
|
• |
Use KM-726-A
(83 96 301 Wrench, oil filter Z18XE)
or KM-921.
|
5. |
Clean the sealing surfaces on the cylinder block and oil ducts.
|
6. |
Fit the new oil filter cartridge:
|
• |
Moisten the sealing ring with engine oil.
|
• |
Tighten the oil filter cartridge. Use KM-726-A or KM-921.
Tightening torque 15 Nm (11 lbf ft) |
7. |
Fit the engine oil drain bolt.
|
• |
Change the sealing ring.
|
• |
Tighten the bolt
Tightening torque 14 Nm (10 lbf ft) |
8. |
Lower the car.
|
9. |
Fill with engine oil:
|
• |
Note the prescribed engine oil volume.
|
• |
Start the engine and allow it to run until the oil pressure control display goes out.
|
• |
Check the engine oil level and top up as necessary. The engine should be warm (after 2-5 min)
|
10. |
Reset the service interval.
|
• |
Acknowledge the service interval in SID. After changing engine oil, the "Remaining mileage" must be acknowledged in SID.
|
• |
Menu item: Saab 9-3
|
• |
Car: Reset service interval
|
11. |
Close the bonnet.
|