Test readings, DVD module (729)
|
|
Test readings, DVD module (729)
|
The following pages contain readings and instructions for measuring signals and levels on the head unit and its control module.
|
•
|
Note the test conditions and use common sense when assessing test results.
|
|
•
|
First check that the control module has a power supply and is grounded.
|
|
•
|
Then check all sensor inputs and signals from other systems.
|
|
•
|
Lastly, check the control module outputs. Remember, the readings do not say anything about whether or not the actuator is in working order.
|
|
•
|
If any reading is not OK, consult the wiring diagram to trace the leads, connectors or components which should be checked more thoroughly.
|
|
•
|
The specified test readings refer to those obtained with a calibrated Fluke 88/97.
|
|
•
|
Test readings %(+) and ms(+) show the signal's pulse ratio and pulse width. A test instrument with pulse ratio and pulse width measurement must be used. The sign (+) indicates a positive trigger pulse, TRIG+.
|
|
Control module connections
|
DVD
|
Pin
|
Component/Function
|
In/Out
|
Test conditions
|
Across
|
Test reading
|
|
1
|
No connection
|
|
|
|
|
|
2
|
+30
|
In
|
Ignition ON
|
2-4
|
B+
|
|
3
|
No connection
|
|
|
|
|
|
4
|
Ground
|
Out
|
Ignition ON
|
4-2
|
B+
|
|
A
|
Optic TX
|
|
Signal unreadable
|
|
|
|
B
|
Optic RX
|
|
Signal unreadable
|
|
|
