Adjusting gear cables
Adjusting gear cables |
To remove |
1. |
Engage neutral.
|
2. |
Push down the gear change shaft and insert
87 92 335 Locking pin
or KM-527-A in the hole in the shaft.
|
3. |
Detach the gear lever cover and rubber mat and lift up the cover. Use
82 93 474 Removal tool
.
|
4. |
Carefully press a screwdriver blade onto the cable adjuster and pry slightly towards the gear lever. A click is heard which means that the adjustment catch has released. Repeat the procedure for the other cable adjuster.
|
6. |
Carefully press the screwdriver against the crescent shaped section of the adjustment catch. When a click is heard the catch has engaged the correct position. Repeat the procedure on the other cable adjuster.
|
7. |
Lift up the adjuster sleeve to its normal position.
|
8. |
Remove the lock pin.
|
9. |
Check the shifting positions.
|
10. |
Fit the gear lever cover and rubber mat.
|