Reversing light switch, replacement or sealing
Reversing light switch, replacement or sealing |
1. |
Remove the connector from the wiring loom to the reversing light switch (1).
|
2. |
Remove the reversing light switch and take off the sealing ring.
|
3. |
Re-fit the reversing light switch to the gearbox with a new sealing ring. Tightening torque 20 Nm.
|
4. |
Re-connect the reversing light switch to the wiring loom.
|
5. |
Check the gearbox oil level and adjust if necessary. See service procedure
Gearbox oil level, checking and correcting F17
.
|