SAAB WIS ONLINE

Synchromesh assembly, removal and fitting

Synchromesh assembly, removal and fitting

To remove

Note

The gearbox remains in place.



1. Remove the reversing light switch (2).


2. Remove the bearing housing cover (3) - see Bearing housing cover gasket, replacement F17 .

3. Remove the main shaft - see Bearing housing, dismantling and assembling, F17 .

4. Dismantle the main shaft. See Main shaft, dismantling and assembly, F17 .



Replace the pertinent synchromesh assembly if necessary.

Note

The 5th gear synchromesh assembly is removed and fitted as described in service procedure Bearing housing, dismantling and assembling, F17 .


To fit


1. Assemble the main shaft. See Main shaft, dismantling and assembly, F 17 .

2. Fit the main shaft - see Bearing housing, dismantling and assembling, F17 .

3. Fit the bearing housing cover (2). See Bearing housing cover gasket, replacement F17 .


4. Re-fit the reversing light switch (4) to the gearbox with a new sealing ring. Tightening torque 20 Nm.

5. Check the gearbox oil level. See Gearbox oil level, checking and correcting F17 .