Bumper shell, rear, 4D
Bumper shell, rear, 4D |
To remove |
1. |
Raise the car.
|
2. |
Remove the centre nuts of the spoiler.
|
3. |
Remove the bolts at the wheel housing.
|
4. |
Lower the car and open the boot lid.
|
5. |
Open the side hatches.
|
6. |
Remove the tail lamp nuts.
|
7. |
Unplug the connector and remove the tail lamp.
|
8. |
Certain cars
: Remove bolts on bumper shell that are located under the tail light.
Cars with SPA: Unplug the connector to the rear bumper shell. Loosen the rubber grommet and pull out the cable. |
9. |
Pull off the bumper shell from the holders and lift it off.
|
To fit |
1. |
Lift up the bumper shell and guide the tabs under the holders.
|
2. |
Position the front corner of the bumper between the wing liner and the holder. Make sure the shell tongue lies between the wing liner and the bumper shell holder.
|
3. |
Press the bumper shell in place at the retainer strip clips.
Cars with SPA: Run the connector through the rear light cluster recess and press the rubber grommet into place. Plug in the connector. |
4. |
Certain cars
: Fit bolts located under the lamp housing.
|
5. |
Fit the bolts at the wing liner.
|
6. |
Plug in the tail lamp connector.
|
7. |
Fit the tail lamp using the guide pins. Check the fit of the boot lid moulding at the tail lamp.
|
8. |
Fit the tail lamp nuts.
|
9. |
Close the side hatches and then the boot lid.
|
10. |
Raise the car.
|
11. |
Fit the centre nuts of the spoiler.
|
12. |
Lower the car and check the fit of the bumper shell.
|