Rear door, outer door panel
|
|
Rear door, outer door panel
|
|
1.
|
The outer door panel is folded over the rear edge of the door structure. Grind the edge so that the outer door panel releases.
|
|
2.
|
Drill out the spot welds.
|
|
3.
|
Knock away the outer door panel and lift off the outer door panel.
|
|
4.
|
Remove the remaining plate strips on the inside of the door structure.
|
|
5.
|
Straighten the edges of the door structure and grind it clean.
|
|
1.
|
Apply sealant on the impact members. Use Terostat 1k-PUR.
|
|
2.
|
Apply glue on the door structure's front and rear edges. Use Teromix 6700.
|
|
3.
|
Apply weld primer to the lower edge of door structure. Use Teroson Zinc spray.
|
|
4.
|
Align the new outer door panel and make sure the plate flanges lie against the door structure. Secure with grips.
|
|
5.
|
Spot weld the door frame on the front edge and underside. Knock down and clamp the upper outer door panel's plate flange.
|
|
6.
|
Knock in the plate flange in the door's rear edge using a hammer. Do not use pliers as this can damage the outside of the door.
|
|
7.
|
Fit the door in place and check its alignment with the body. Adjust as necessary.
|
|
8.
|
Wash off surplus welding primer. Welding primer makes for poorer adhesion of paint, filler and sealant.
|
|
9.
|
Apply primer on all ground surfaces. Use Standox 1K Primer Filler.
|
|
10.
|
Use Terostat 1K-PUR to seal joints and metal folds.
|
|
11.
|
Apply anti-corrosion agent to the door after it has been painted.
|
