MIG brazing equipment
MIG brazing equipment |
In the event of sheet metal damage in an area with MIG brazing, a new method must be used that requires a new type of equipment.
Depending on the equipment and the sheet metal thickness, different welding equipment settings are required. These are known as welding parameters.
Ensure that independent workshops have parameters for the localised areas as well as the relevant method from WIS. In all cases, pure argon gas is to be used and the welding wire must be 1 mm.
|
The following equipment is approved for MIG brazing:
• |
Cloos GLC 353 MC3 with CK 98 A
Reference no.: OP 510402 Internet address: www.cloose.de |
• |
ELMATech MIDI - MIG 300/800
Reference no.: SA.20268.1 Internet address: www.elmatech-aq.com |
• |
Fronius TPS2700 4R/E
Reference no.: TPS2700 4R/E Internet address: www.fronius.com |
• |
Kemppi Pro 3200 EVO with Promig 530 incl. MXE - Panel
Reference no.: PROMIG 3200 OPEL Internet address: www.kemppi.com |
• |
Migatronic Flex 3000 XMI-L with MWF 15/CMI3000
Reference no.: 79541063 Version GM Internet address: www.migatronic.com www.car-o-liner.se |
• |
Wielander & Schill InvertaPuls IP 10 Digital
Reference no.: 331010 Internet address: www.wielanderschill.com |
• |
MIDI-MIG 300/800
Internet address: www.celette.com |