Compression check
Compression check |
1. |
Engine at running temperature (oil temperature >= 80°C).
|
2. |
Remove the engine protection cover.
|
3. |
Pull off the cable set connector (2) from the ignition module (3).
|
4. |
Remove the ignition module form the camshaft cover and cylinder head respectively and pull it off the spark plugs using KM-6009 (
83 96 335 Removal tool, ignition discharge module Z18XE
) (1).
Remove the spark plug using 83 95 485 Spark plug socket, with guide sleeves . |
5. |
Open the throttle valve using TECH II - use the "compression test" program (TECH II). Use a compression tester with measuring range up to 1750 kPa (17.5 bar).
|
6. |
Run the starter motor for about 4 seconds - min 300 rpm. The pressure difference between cylinders should not exceed 100 kPa (1 bar).
|
7. |
Fit the spark plugs with
83 95 485 Spark plug socket, with guide sleeves
- tightening torque 25 Nm.
|
8. |
Put the ignition module onto the spark plugs and fit it onto the camshaft cover - tightening torque 8 Nm.
|
9. |
Fit the ignition module cable set connector.
|
10. |
Fit the engine cover.
|