Crankshaft rear sealing ring, change
Crankshaft rear sealing ring, change |
To remove |
1. |
Remove the manual gearbox
Instruction: remove the manual gearbox - see Gearbox, removing an fitting, F 17 |
2. |
Remove the clutch
Instruction: remove the clutch - see Clutch - overview, F17 |
3. |
Remove the flywheel
Use 83 94 868 Flywheel locking attachment. 6x Undo the bolt |
4. |
Remove the crankshaft rear sealing ring
Important: do not damage sealing surface Place a receptacle underneath Prise loose the crankshaft rear sealing ring |
5. |
Clean the sealing service
|
6. |
Fit the crankshaft rear sealing ring
Moisten the sealing lip with grease Place KM-235-D ( 83 96 293 Fitting tool rear crankshaft seal, Z18XE ) (1) onto the crankshaft journal Push the sealing ring (2) onto KM-235-D ( 83 96 293 Fitting tool rear crankshaft seal, Z18XE ) Strike in the sealing ring flush - Use KM-658-1( 83 96 285 Fitting tool rear crankshaft seal, Z18XE ) (3) |
7. |
Clean the threads.
6x Clean the threads - in the crankshaft |
8. |
Fit the flywheel
Instruction: Use new bolts 6x Tighten the bolt - Tightening torque 35 Nm + 30° + 15° - Use 83 94 868 Flywheel locking attachment . |
9. |
Clean the flywheel
|
10. |
Fit the clutch
Instruction: Fit the clutch - see Clutch - overview, F17 |
11. |
Fit the manual gearbox
Instruction: Fit the manual gearbox - see Gearbox, removing an fitting, F 17 . |
12. |
Check and adjust the engine oil level.
Note the prescribed engine oil volume |