Tooth belt tensioning pulley, removing and fitting
Tooth belt tensioning pulley, removing and fitting |
To remove |
Remove the top of the tooth belt cover - see Tooth belt cover top part, removing and fitting .
Remove the multi-belt - see Multi-belt, removing and fitting .
Remove the multi-belt tensioning pulley - see Tensioning device for multi-belt, removing and fitting .
Remove the bottom of the tooth belt cover - see Tooth belt cover bottom part, removing and fitting .
Tooth belt tensioning pulley |
1. |
Remove the tooth belt tensioning pulley (1) from the oil pump.
|
2. |
Fit the tooth belt tensioning pulley on the oil pump - torque tighten only after adjusting the tooth belt tension.
Caution Make sure the locking arm (2) on the drive belt tensioning pulley engages in the grooves (3) on the oil pump. |
Adjusting |
1. |
Put on the tooth belt - check that the pull side (I) is taut.
Caution Note the valve timing marks! |
2. |
Adjust the tooth belt tension - see procedure
Tooth belt tension, setting
.
|
3. |
Fit the camshaft sensor to the cylinder head - fit the bolts with locking compound (red) - tightening torque 8 Nm.
|
To fit |
1. |
Fit the bottom of the tooth belt cover - see
Tooth belt cover bottom part, removing and fitting
.
|
2. |
Fit the tensioning device for the multi-belt - see
Tensioning device for multi-belt, removing and fitting
.
|
3. |
Fit the multi-belts - see
Multi-belt, removing and fitting
.
|
4. |
Fit the top of the tooth belt cover - see
Tooth belt cover top part, removing and fitting
.
|