Crankshaft impulse sensor, removing and fitting

/ 9-3 (9440) / 2006 / 2. Engine / 1.8 XE petrol / Simtec engine management system / Adjustment/replacement / Crankshaft impulse sensor, removing and fitting

1.	Take off the crankshaft impulse sensor cable set connector (1) - expose the cable.

2.	Remove the impulse sensor (2) from the holder.

3.	Fit the crankshaft impulse sensor to the cylinder head - tightening torque 8 Nm.

4.	Connect the cables set connector for the crankshaft impulse sensor - pull on the cable harness.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.