SAAB WIS ONLINE

Engine management system EDC16 (Part 4/4)

Engine management system EDC16 (Part 4/4)


List of components

No. Name Location Illus.
Components
1 Battery
136 Oxygen sensor, on the catalytic converter
229 Main relay, engine control system in underhood electrical centre 342
271 Heated oxygen sensor element, integrated in the oxygen sensor
342 Underhood electrical centre 342 (UEC) , next to battery 1
398a Glow plug, cylinder 1, on upper rear section of engine
398b Glow plug, cylinder 2, on upper rear section of engine
398C Glow plug, cylinder 3, on upper rear section of engine
398d Glow plug, cylinder 4, on upper rear section of engine
595 Control module, EDC16, between the front spoiler and right-hand wheel housing A B
596 Control module, glow plug, on the side of the battery cover
602F Exhaust temperature sensor, front, component: in the inlet to the first catalytic converter connector: on the bracket beside the turbo
602R Exhaust temperature sensor, rear, component: in the front edge of the rear catalytic converter connector: on the bulkhead partition below the coolant reservoir
606 EGR solenoid unit, under the throttle body
744 Pressure sensor, exhaust system, on the bulkhead partition below the coolant reservoir
746a Fuse holder, power steering on the side of the battery cover
6-pin connector
H6-1 Behind field rail
11-pin connector
H11-1 On RH side of engine by the fuel pump
Crimp connections
J265 Approx. 30 mm from branching point intake air sensor towards the engine control module
J266 Approx. 140 mm from branching point intake air sensor towards the engine control module
J267 Approx. 100 mm from connector A to the engine control module
J270 Approx. 200 mm from branching point starter motor towards the reversing light switch
J271 Approx. 100 mm from branching point starter motor towards the reversing light switch
J273 Approx. 50 mm from branching point starter motor towards the engine control module
J274 Approx. 310 mm from branching of connector H11-1 toward engine control module
J278 Approx. 50 mm from branching of connector H24-5 toward starter motor
J280 Approx. 200 mm from branching of connector H24-5 toward starter motor
Grounding points
G2 On the side of the left structure strut by the connector bracket