Front cylinder head gasket
|
Front cylinder head gasket
|
3.
|
Remove the nut (A), bolt (B), bolts (C) and turbocharger holder (D). Move out the heat shield slightly.
|
4.
|
Remove the bolts (A), slightly slacken the bolt (B) of the power steering pump bracket.
|
5.
|
Remove the cylinder head bolts in the order depicted.
|
6.
|
Lift off the cylinder head.
|
7.
|
Clean the gasket and clean the sealing surfaces.
|
8.
|
Check the sealing surfaces for damage or distortion.
|
1.
|
Place a new gasket on the cylinder block.
|
2.
|
Fit the cylinder head. Fit and tighten the M11 bolts in the depicted order. Use new bolts.
Tightening torque:
Stage 1: 45 Nm (33 lbf ft)
Stage 2: Tighten the bolts 120°
|
3.
|
Fit and tighten the M8 bolts (A).
Tightening torque:
Stage 1: 15 Nm (11 lbf ft)
Stage 2: Tighten the bolts 60°
|
4.
|
Fit the turbocharger holder (D), bolts (C), bolt (B) and nut (A).
Tightening torque, bolt (C): 65 Nm
|
5.
|
Fit the power steering pump bracket.
Tightening torque, bolt (A) and (B): 38 Nm (28 lbf ft)
|