Preheated oxygen sensor, rear (593)

Warning

The exhaust pipe from the turbocharger can be extremely hot. Proceed with caution.

Important
The oxygen sensor cables must not be twisted. Twisted cables in combination with vibrations can lead to cable breaks.
The oxygen sensor is sensitive to knocks and jolts and must be handled with care.

To remove

Important
Always use wing covers when working in the engine bay.

Remove the upper engine cover.

Important
Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .

Detach the lower oxygen sensor connector and remove the cable fixings.

Carefully raise the heat shield slightly. Use 83 96 350 Removal socket, oxygen sensor when the oxygen sensor is removed.

To fit

Lightly coat the threads with 90 513 210 Universal paste and fit the oxygen sensor using 83 96 350 Removal socket, oxygen sensor .

Tightening torque: 45Nm (33 lbf ft)

Carefully press down the heat shield.

Important
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .

Secure the cable and plug in the connector.

Replace the upper engine cover.

Remove the wing cover.