Throttle body actuator unit (604)
Throttle body actuator unit (604) |
To remove |
Important | ||
Always use wing covers when working in the engine bay. |
||
Before replacement, Procedure before control module removal must be carried out.
1. |
Remove the engine cover.
|
2. |
Remove the power steering fluid reservoir bolt. Put the reservoir aside.
|
3. |
Unplug the connector of the intake air sensor (688).
|
4. |
Remove the charge air pipe.
|
5. |
Remove the throttle body bolts.
|
6. |
Unplug the conenctor and lift away the throttle body.
|
To fit |
1. |
Clean the sealing surfaces. Position the throttle body using a new seal. Plug in the connector.
|
2. |
Fit the throttle body bolts.
Tightening torque 9 Nm |
3. |
Replace the charge air pipe.
|
4. |
Plug in the connector of the intake air sensor (688).
|
5. |
Position the power steering fluid reservoir and fit the bolt.
|
6. |
Fit the engine cover.
|
7. |
If a new throttle body has been fitted: Connect the diagnostic tool for programming. Select Diagnosis / Select model year / Saab 9-3 Sport (9440) / All / Add/Remove / Other components / 2.8T - Replaced Throttle Body.
|