Starter motor, replace, Z18XE
|
Starter motor, replace, Z18XE
|
2.
|
Disconnect the battery.
Detach the ground cable
|
4.
|
Unplug the wiring harness connector for the catalytic converter control's oxygen sensor (1)
|
5.
|
Remove the support for the intake manifold:
- Undo the bolts (arrows)
|
6.
|
Remove the starter motor wiring:
- Undo the nut (1)
|
7.
|
Remove the starter motor:
- Undo the bolt
|
1.
|
Fit the starter motor:
- Tighten the bolt - Tightening torque 25 Nm
|
2.
|
Fit the starter motor wiring:
- Tighten the nut
|
3.
|
Fit the support for the intake manifold:
- on the intake manifold - Tighten the bolt - Tightening torque 20 Nm
- on the engine block - Tighten the bolt - Tightening torque 35 Nm
|
4.
|
Fasten the wiring harness connector for the catalytic converter control's oxygen sensor.
|