Amplifier, front speaker (354F), CV
|
|
Amplifier, front speaker (354F), CV
|
|
Important
|
|
The optic cables must be handled carefully so as not to distort the signal.
|
|
•
|
It is extremely important that the two leads in the connector are not mixed up.
|
|
•
|
The cables cannot be spliced.
|
|
•
|
The lead must not be bent to form a curve with a radius of less than 25 mm.
|
|
•
|
The lead must not be subjected to temperatures greater than 185°F (85°C).
|
|
•
|
The lead ends should be kept free from dirt.
|
|
•
|
The lead must not be subjected to blows that could cause the transparent plastic to whiten, thereby reducing light intensity. This could cause disruptions in communication.
|
|
•
|
The lead should not be stretched across a sharp edge, which would cause increased damping of the signal.
|
|
|
Warning
|
|
The red visible light is of laser class 1. Do not look directly into the optic fibre or the control module connector at close range. At a distance of less than 20 mm from your eyes to the light source, your eyes could be damaged.
|
|
|
|
|
|
Carry out
actions before removing control module
.
|
2.
|
Unplug the connector.
|
|
3.
|
Remove the bracket screws.
|
|
4.
|
Remove the amplifier retaining screw.
|
|
5.
|
Remove the amplifier from the bracket.
|
|
1.
|
Fit the amplifier into the bracket.
|
|
2.
|
Fit the amplifier retaining screw.
|
|
3.
|
Fit the assembled amplifier and bracket.
|
|
4.
|
Fit the bracket screws.
|
Important
|
|
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to
Connectors, handling and inspection
.
|
|
|
|
|
5.
|
Plug in the connector.
|
