SAAB WIS ONLINE

Adjusting gear cables

Adjusting gear cables

To remove


1. Engage neutral.

2. Push down the gear change shaft and insert 87 92 335 Locking pin or KM-527-A in the hole in the shaft.


3. Detach the gear lever cover and rubber mat and lift up the cover. Use 82 93 474 Removal tool .


4. Carefully press a screwdriver blade onto the cable adjuster and pry slightly towards the gear lever. A click is heard which means that the adjustment catch has released. Repeat the procedure for the other cable adjuster.

5. Secure the gear lever in its adjustment position by lifting the adjusting sleeve while pressing in the two catches. Use a suitable pair of pliers. Let the catch engage adjusting position (neutral position to the left).


Important

Counterhold the adjusting sleeve when the catches are depressed.


6. Carefully press the screwdriver against the crescent shaped section of the adjustment catch. When a click is heard the catch has engaged the correct position. Repeat the procedure on the other cable adjuster.


7. Lift up the adjuster sleeve to its normal position.

8. Remove the lock pin.

9. Check the shifting positions.

10. Fit the gear lever cover and rubber mat.