Front brake disc
| Front brake disc |
| Note | ||
|
Both brake discs should be changed at the same time to ensure good braking efficiency. |
| To remove |
| 1. |
Raise the car and remove the wheel.
|
|
| 2. |
Press in the piston.
|
|
| - |
Levels 1, 2 and 4:
Prise against the brake pad with a screwdriver.
|
| - |
Level 3:
Prise between the brake disc and the brake caliper using a screwdriver.
|
| 3. |
Remove the two brake caliper retaining bolts.
|
|||||||
| 4. |
Suspend the brake caliper from the spring strut.
|
|
| 5. |
Remove the brake disc locking screw.
|
|
| 6. |
Lift off the brake disc.
|
|
| To fit |
| 1. |
Clean the new brake disc.
|
|
| 2. |
Clean all the contact surfaces between the hub and the brake disc.
|
|
| 3. |
Place the brake disc on the hub and screw in the brake disc locking screw.
Tightening torque 7 Nm (5 lbf ft) 
|
|
| 4. |
Fit the brake caliper. Secure the bolts with
74 96 268 Thread locking adhesive
.
Tightening torque: 210 Nm +30° (155 lbf ft +30°) 
|
|
| 5. |
Fit the wheel
.
|
|
| 6. |
Lower the car and press the brake pedal to press out the brake pads.
|
|
| 7. |
Test drive the car and check the operation of the brakes.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
