Procedures after disconnecting the battery
|
Procedures after disconnecting the battery
|
1.
|
Clear diagnostic trouble codes in all systems.
Important
|
Some diagnostic trouble codes can be generated if there is a voltage drop. These diagnostic trouble codes can be ignored and will not be regenerated after deletion.
|
|
|
2.
|
Set the clock as follows:
|
|
2.a.
|
Turn the ignition key to the ON position.
|
|
2.b.
|
Press CUSTOMIZE on SIDC (SID control panel).
|
|
2.c.
|
Turn the INFO knob until the displays shows “Clock/Alarm”. Press to confirm "OK".
|
|
2.d.
|
Turn the INFO knob to “Set Clock”. Press "OK".
|
|
2.e.
|
Turn the INFO knob to “Manual” or "RDS adjust" and set the correct time. Press "OK".
|
3.
|
Set the date as follows:
|
|
3.a.
|
Turn the ignition key to the ON position.
|
|
3.b.
|
Turn the INFO knob to "DATE".
|
|
3.c.
|
Press the INFO knob until the display shows "YEAR 2000".
|
|
3.d.
|
Turn the INFO knob to the correct year. Press to confirm "OK".
|
|
3.e.
|
Turn the INFO knob to the correct month. Press "OK".
|
|
3.f.
|
Turn the INFO knob to the correct date. Press "OK".
Important
|
Draw the customer's attention to the fact that all remote controls must be synchronised by placing the key/keys in the ignition lock. If this is not done, the remote control will not work.
|
|
|
4.
|
Synchronise the remote control's code by inserting the key in the ignition switch.
Warning
|
The trap protection is not active until the window lifters have been calibrated after a power failure.
|
|
|
|
|
|