Rear brake pads
Rear brake pads |
To remove |
1. |
Raise the car.
|
2. |
Remove the wheel.
|
3. |
Remove the retaining spring from the brake caliper.
|
4. |
Remove the protective covers and guide pins.
Lift off the hydraulic body. |
5. |
Remove the inner brake pad from the caliper and the outer brake pad from the bracket.
Clean the inside of the brake caliper and check the dust covers. |
6. |
Screw in the brake piston with
89 96 969 Resetting tool
and
89 96 977 Adapter
.
|
To fit |
1. |
Lubricate the pad sliding and contact surfaces with
Special paste
.
|
2. |
Fit the brake pads.
|
3. |
Fit the hydraulic body.
Tightening torque 28 Nm (21 lbf ft) Fit the protective covers. |
4. |
Fit the retaining spring to the brake caliper.
|
5. |
Fit the wheel
.
|
6. |
Lower the car.
|
7. |
Press the brake pedal a few times to press out the brake pistons and the handbrake adjustment.
|
8. |
Check the brake fluid level and top up as necessary.
|
9. |
Check the operation of the foot brake and handbrake.
|