Rear spoiler shield

/ 9-3 (9440) / 2006 / 8. Body / Body / Auxiliaries / Adjustment/replacement / Rear spoiler shield

To remove

1.	Raise the car.

2.	Remove the spoiler nuts and bolts.

3.	Remove the spoiler. Start from the sides and pull the spoiler loose so that the mountings release from the bumper shell.

4.	Remove the nut inside the bumper shell.

5.	Remove the bolts at the wing liner.

6.	Lift aside the spoiler shield.

To fit

1.	Position the rear spoiler shield.

2.	Fit the bolts at the wing liner.

3.	Fit the nut inside the shell. Make sure the rear attachment point fits on the weld screw.

4.	Use the guide pin to position the spoiler. Press the clips into the bumper shell holder.

5.	Fit the spoiler nuts and bolts.

6.	Lower the car and check the fit.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.