Roof moulding, 5D
| Roof moulding, 5D |
| To remove |
| 1. |
Begin at the front edge of the moulding's inside using
82 93 474 Removal tool
.
|
|
| To fit |
| 1. |
Coax the weatherstrips into the roof moulding groove. Use lubricant and make sure that the weatherstrip is not stretched.
|
|
| 2. |
Lift out the weatherstrip ends and glue them to the front and rear edge of the roof moulding.
|
|
| 3. |
Cut off the weatherstrip at both ends.
|
|
| 4. |
Adjust the clips so they sit straight against the roof holder.
|
|
| 5. |
Begin fitting the moulding from the front. Make sure the roof moulding lies under the windscreen moulding. Press in the moulding so that the clips fasten.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
