Sill cover
| Sill cover |
| To remove |
| 1. |
Remove the bolts at the wheel housings.
|
|
| 2. |
Loosen the rubber moulding of the sill cover. Do not pull loose the clip in the front edge.
|
|
| 3. |
Remove the sill cover bolts behind the rubber moulding.
|
|
| 4. |
Remove the clips by tapping up the centre pin. Pull out the clips.
|
|
| 5. |
Detach the clips at the rear door opening. Lift out the rear edge of the sill cover. Slide the cover forward so the catch releases from the front wing. Put the clip centre pins in a safe place.
|
|
| To fit |
| 1. |
Fasten the cover to the front wing and make sure the front wing guide tab fits into the groove in the cover. Lift up the rear edge and guide in the clip at the rear door.
|
|
| 2. |
Fit the bolts behind the rubber moulding.
|
|
| 3. |
Press the rubber moulding in place and fit its rubber clip in the rear sill cover. Check that the rubber clip sits correctly in the front edge.
|
|
| 4. |
Fit the cover bolts at the wheel housings.
|
|
| 5. |
Fit the clips and tap in the centre pins. Check the fit of the sill cover.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
