SAAB WIS ONLINE

Door handle, CV

Door handle, CV

To remove


1. Remove Door trim, CV .

2. Left door: Remove Side window, door, CV .

Right door: Raise the window to the highest position. Fold down the water barrier.

3. Cars with guard : Remove the guard's screws.


4. Remove the lock cover from the rod.

5. Loosen the rod from the clip.

6. Remove the lock unit bolts. Allow the lock to hang freely.


7. Cars with guard : Remove the guard by pulling the guard forward and downward and then lifting it out.

8. Remove the upper rear nut for the handle and lock cylinder.


9. Left door : Turn the lock cylinder anti-clockwise and pull out the cylinder from the handle.

10. Left door :Unhook the cylinder and remove the cylinder from the lock rod.


11. Remove the nuts from the opening handle.


12. Remove the reinforcement plate.

13. Lift out the handle by:

13.A. Pull out the lower edge of the handle so that the studs release.


13.B. Pull downwards to get out the handle counterweight.

13.C. Now lift upwards to get the handle's rod out through the hole.


To fit


1. Check the handle's gasket so that it is in one piece and located correctly.

2. Fit the handle by:

2.A. Fit the handle rod in the door.

2.B. Angle in the handle's counterweight.

2.C. Angle in the handle's lower edge and insert the studs in the holes.


3. Fit the reinforcement plate.


4. Fit the front and lower rear nuts on the opening handle.

5. Left door : Hook the lock cylinder to the rod.


6. Left door : Fit the lock cylinder by pushing the lock cylinder and turning it clockwise.


7. Fit the handle's upper rear nut.

8. Cars with guard : Insert the guard. Make sure the rod from the handle is in front of the guard.


9. Lift up the lock and secure it with a bolt. Also, thread the bolts for the guard (certain cars only) and lock. Start by tightening the lock bolts followed by the guard bolts.

10. Push the rod into the clip.

11. Lift in the clip at the same time as you fit the lock cover to eliminate play.

12. Check the function of the handle, lock cylinder and lock.

13. Left door : Fit Side window, door, CV .

14. Fit the plastic water barrier.

15. Fit the Door trim .

16. Cars with pinch protection : Perform Programming of the pinch protection .