SAAB WIS ONLINE

Lock cylinder, CV

Lock cylinder, CV

To remove


1. Lower the door window fully and then raise it roughly 10 cm. Remove Door trim, CV .

2. Remove the Side window, door, CV .

3. Cars with guard : Remove the guard's screws.


4. Remove the lock cover from the rod.

5. Loosen the rod from the clip.

6. Remove the lock unit bolts. Allow the lock to hang freely.


7. Cars with guard : Remove the guard by pulling the guard forward and downward and then lifting it out.

8. Remove the upper rear nut for the handle and lock cylinder.


9. Turn the lock cylinder anticlockwise and pull out the cylinder from the handle.

10. Unhook the cylinder and remove the cylinder from the lock rod.



To fit


1. Hook the lock cylinder on the rod.


2. Fit the lock cylinder by pushing the lock cylinder and turning it clockwise.


3. Fit the handle's upper rear nut.

4. Cars with guard : Insert the guard. Make sure the rod from the handle is in front of the guard.

5. Lift up the lock and secure it with a bolt. Also, thread the bolts for the guard (certain cars only) and lock. Start by tightening the lock bolts followed by the guard bolts.


6. Fit the rod in the clip.

7. Lift in the clip at the same time as you fit the lock cover to eliminate play.

8. Check the function of the lock, lock cylinder and the outer handle.

9. Fit the Side window, door, CV

10. Fit the plastic water barrier.

11. Fit the Door trim .

12. Cars with pinch protection : Perform Programming of the pinch protection .