Position sensor, sixth bow raised (578u)
Position sensor, sixth bow raised (578u) |
To remove |
Only the hydraulic cylinder mounted on the right-hand side of the car is equipped with a position sensor.
1. |
Open the soft top fully and leave the soft top cover open.
|
2. |
Remove
Seat cushion, rear seat, CV
,
Backrest, rear seat, CV
and the right-hand
Rear side trim, CV
.
|
3. |
Close the soft top and leave the soft top cover and sixth bow open. Secure with the soft top support.
|
4. |
Remove the pin lock.
|
6. |
Remove the hydraulic cylinder piston rod from the fastening pin on the soft top mechanism and lift out the cylinder.
|
7. |
Remove the position sensor cable tie.
|
8. |
Remove the position sensor cable connector (grey).
|
9. |
Use a screwdriver to carefully loosen the position sensor from the hydraulic cylinder.
|
To fit |
1. |
Fit the position sensor on the cylinder.
|
2. |
Connect the position sensor cable connector.
|
3. |
Put the hydraulic cylinder in mounting position. Fit the piston rod on the soft top mechanism fastening pin.
|
5. |
Fit the locking ring.
|
7. |
Remove the soft top support and close the soft top.
|
8. |
Manoeuvre the soft top through 5 complete cycles in order to check soft top function.
|
9. |
Fit
Rear side trim
,
Seat cushion, rear seat
and
Backrest, rear seat
.
|
10. |
Connect the diagnostics tool and erase any diagnostic trouble code.
|