SAAB WIS ONLINE

AHL / B1325 03

Read the instructions below then start the fault diagnostic procedure.

Symptom: Message appears in display. Headlamp beam adjustment not working.

  B1325 03


Control Module, Supply Voltage Low

Fault symptom

Message appears in display.

Headlamp beam adjustment not working.

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Ignition ON.

Fault criteria:

Input voltage below 9 V for more than 0.12 s.

System reaction to a fault:

Headlamp beam adjustment is switched off.

OK report:

Input voltage exceeds 9.5 V for more than 0.12 s.

Checking the wiring harness

Jiggle the wiring harness at several points to detect intermittent breaks or short circuits. Check also the connector for oxidation or loose pins.

Diagnostic help

IMPORTANT

See "Safety and handling directions, xenon headlamps".