AHL / B3415 01
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Message appears in display.
Headlamp beam adjustment not working.
Axle Sensor Supply, Short to B+
Fault symptom
Message appears in display.
Headlamp beam adjustment not working.
On-board diagnosis
Type of diagnosis:
Enable criteria:
Car speed over 10 km/hr for more than 5 s. |
Fault criteria:
Control module output short-circuit to B+. |
System reaction to a fault:
Headlamp beam adjustment is switched off. |
Headlamp reflectors adjusted to a lower position. |
Checking the wiring harness
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.
Diagnostic help
Before fault diagnosis begins, read the document "Safety and handling directions, xenon lights" under Technical description.
DTC can be generated if any of the height sensors are incorrectly fitted.
Height sensor lower limit value is 205 steps and upper limit value is 3890 steps.