AMP2 / B1016 00
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Control module not configured.
Control Module not Added
Fault symptom
Control module not configured.
On-board diagnosis
Type of diagnosis:
| Each time ignition is switched OFF and after VIN programming. |
Enable criteria:
| Starter motor cranking or engine running. |
Fault criteria:
| Control module not configured. |
Diagnostic help
Control module was not added.
See "Procedure after fitting the control module"
Diagnostic help
Functions in the diagnostic tool related to the fault:
| See menu "All - Add/Remove" |
