BCM / B1001 46
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Message appears in display.
Control Module not Added
Fault symptom
Message appears in display.
On-board diagnosis
Type of diagnosis:
Enable criteria:
Diagnostics run when ignition is ON. |
Fault criteria:
Control module not configured. |
System reaction to a fault:
The control module sends out the bus message that it is not programmed. Depending on whether or not the control module has a PIN code programmed, immobilizer-related functions are switched off. |
Diagnostic help
See "After fitting a control module" under fault diagnosis, general.
Diagnostic help
Functions in the diagnostic tool related to the fault:
See menu "All - Add/Remove" |