CDF / B1016 00
Read the instructions below then start the fault diagnostic procedure.
Symptom: Error message is shown on the display.
| B1016 00 |
Control Module not Added
Fault symptom
Error message is shown on the display.On-board diagnosis
Type of diagnosis:
| Diagnostics runs each time the control module is active and when programming has been carried out. |
Enable criteria:
| Ignition ON. |
Fault criteria:
| Control module not configured. |
Diagnostic help
Control module was not added.See "Procedure after fitting the control module"
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
