SAAB WIS ONLINE

CIM / B1000 39

Read the instructions below then start the fault diagnostic procedure.

  B1000 39


Control Module. Internal fault



On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Diagnostics performed when control module goes to standby.
The diagnosis is carried out each time the car is locked/unlocked by the remote control.

Fault criteria:

Control module has detected an internal fault.

Diagnostic help

Prior to software version 12800185, a DTC could be generated if the speed exceeded 5 km/h after turning the ignition key to LOCK. Carry out SPS programming if the software is older than software version 12800185.

See "Before changing a control module" and "After fitting a control module" under Fault diagnosis, general.

Diagnostic help

Diagnosis regards:

To locate electrical faults in the control module internal electronics.

Functions in the diagnostic tool related to the fault:

See menu "All - Add/Remove"