SAAB WIS ONLINE

EDC16 / P0110 11

Read the instructions below then start the fault diagnostic procedure.

Symptom: Fault indicator lamp (for further information see WIS Fault diagnosis, general) Performance loss.

  P0110 11


Intake Air Temperature Sensor Circuit. Short to B+ / Open Circuit.

Fault symptom

Fault indicator lamp (for further information see WIS Fault diagnosis, general)

Performance loss.

On-board diagnosis

Type of diagnosis:

Continuous

Enable criteria:

Ignition ON.

Fault criteria:

When input voltage exceeds 4.9 V for more than 0.5 seconds.

System reaction to a fault:

Control module uses 40 degrees C as substitute value.

OK report:

Input conditions fulfilled without a fault reported.

Checking the wiring harness

Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force.
Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force.

Diagnostic help

Diagnosis regards: