EDC16 / P0530 07
Read the instructions below then
start the fault diagnostic procedure.
Symptom: No cooling.
A/C Pressure Sensor, Short to B+
Fault symptom
No cooling.
On-board diagnosis
Type of diagnosis:
Enable criteria:
Fault criteria:
| Input voltage is higher than 4.9V for more than 0.6 s. |
System reaction to a fault:
| The control module uses a substitute value of 101 kPa. |
| The control module deactivates the output to the A/C relay. |
OK report:
| Fault criteria NOT fulfilled for 0.6 s. |
Checking the wiring harness
| • | Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force. |
| • | Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force. |
Diagnostic help
Diagnosis regards:
Functions in the diagnostic tool related to the fault:
| (See also description of readings/activations in diagnostic tool) |
