EDC16 / P0615 04
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Starter motor cannot be started.
Starter Relay Actuator Circuit, Open
Fault symptom
Starter motor cannot be started.
On-board diagnosis
Type of diagnosis:
Enable criteria:
Fault criteria:
| No voltage on the control module output for more than 0.6 s |
System reaction to a fault:
OK report:
| Fault criteria NOT fulfilled for 6.5 s. |
Checking the wiring harness
| • | Faults in the control module female connector can be the cause of the DTC. Check the connector with respect to oxidation, depressed pins and pin clamping force. |
| • | Move the wiring harness at several spots and in several directions to reveal intermittent breaks and short-circuits. Check switches, connectors and crimp connections for oxidation, retracted pins and pin clamping force. |
Diagnostic help
Diagnosis regards:
Functions in the diagnostic tool related to the fault:
| (See also description of readings/activations in diagnostic tool) |
